Overburden Stress Shale Causes Stuck Pipe

Overburden stress increases over depth (the more a well is drilled, the more overburden stress will be seen). When mud weight is not enough to support the overburden, the stress from the overburden will create shale fractures which will fall down into the wellbore. Finally, shale fractures will pack the wellbore and cause a stuck pipe incident,

(Mud weight is high enough to overcome overburden stress.)

Overburden Stress Causes Stuck Pipe 2

(Mud weight is not high enough to overcome overburden stress.)

Warning signs of overburden stress shale

• Torque and drag increase.

• Pump pressure increase.

• Abnormal amount of shale at shale shakers

• Caving shape of shale at shakers

Indications when you stuck due to overburden stress shale

• It could be happened either while tripping or drilling (most likely while drilling).

• When it happens, the hole may be completely packed off or bridged off; therefore, circulation is very difficult or impossible to establish.

What should you do for this situation?

1. Attempt to circulate with low pressure (300-400 psi). Do not use high pump pressure because the annulus will be packed harder and you will not be able to free the pipe anymore.

2. If you are drilling or POOH, apply maximum allowable torque and jar down with maximum trip load.

3. If you are tripping in hole, jar up with maximum trip load without applying any torque.

4. Attempt until pipe free and circulate to clean wellbore.

Preventive actions:

1. Use drilling mud that heavy enough to stabilize overburden stress.

2. Weight up mud prior to drilling into stressed shale zones.

Reference: Overburden Stress Shale Causes Stuck Pipe in Drilling Formulas blog

View the original article here


Post a Comment

Related Post